By visiting our site, you agree to our privacy policy regarding cookies, tracking statistics, etc.

TUTORIALS

TUTORIAL PROTECTIVE COVER

HOW TO PROTECT WINEGLOBE FROM LIGHT?

Please check the condition of all the elements before using them (globe, seal, lid, stan, etc…)

  1. Unflod the cover and place it with the rubber band towards the bottom
  2. Fit the cover over the Wineglobe.
  3. Pull the rubber band down on one side, then on the other
  4. Make sure that the cover entirely covers the reck

TUTORIAL LID

HOW TO PUT THE WINEGLOBE LID ?

Please check the condition of all the elements before using them (globe, seal, lid, stan, etc…)

  1. Put the seal on the globe
  2. Put the lid on the globe
  3. Check if the lid is centered over the globe : you can use your fingers to evaluate the gap between glass and brackets
  4. Unscrew, move and re-screw the screw in the interior hole. The brackets passes under the cover
  5. Tighten each screw crosswise one after the other (tightening torque: 6N.m – 22N.m)
  6. Insert the silicone bung on the lid
  7. Insert the bubbler into the bung and fill the bubbler with water at 10% of SO2 (nearly 5 cm)

TUTORIAL HARNESS

HOW TO MOVE THE WINEGLOBE WITH THE HARNESS?

Check the condition of the WG200L harness before use.

  1. Unfold the harness and place the blue-colored strap on the upper part of the globe
  2. Put the harness on the Wineglobe. Reposition the straps so that they are all flat.
  3. Tighten the strap using the buckle. The remaining strap should be fastened
    onto the Velcro square.
  4. The harness is in place, now you can move the globe (moving and turning upside).